How to Measure My Ring Size

The question is often asked: “How do I find my ring size”.

The easiest solution is to visit a jewellery shop and ask them to measure the size of your ring finger.

Here we hope to provide you with all you need to understand so you will find the size that best fits, even when shopping from home - after all, sometimes size does matter!

There are two methods to measure your ring size:

One:  Measure your own ring

Measure one of your own rings using a ruler. Lay the ring on a flat surface and place a ruler on top of the ring. Measure the ring (inside diameter) on the widest part of the ring. When it comes to selecting the perfect ring size, precision is key, as even a few millimetres can make a difference.

Two:  Measure your own finger

Step 1: Measure your finger by wrapping a strip of paper or wide thread around it, leaving enough space to slide the wrapped paper over your knuckle.

Step 2:  Before sliding the paper off your finger, use a pen to mark the place where the paper strip ends cross over each other.  Remove the paper from your finger, unroll it and measure the length against a ruler - from the end of the paper to the mark you made.

This is the circumference of your finger, which corresponds to an Australian ring size  eg if the measurement is 60mm then this corresponds to a ring size P. If you fall in between sizes, we recommend that you chose the larger size or state P.5  as a halfway between a P and a Q size.

As a rule of thumb, you can always remember that you will probably need a slightly bigger size is if the ring is wide versus slim. If the ring is sleek and slim we recommend that you opt for a lightly smaller size eg. 0.5 size difference.

This method can be used to find the ring size of any of your fingers.

Please note that the ring size can vary depending on the ring design and fit on your finger.